1. wings
1.1. Use a big enough paper (packing paper or wallpaper).
1.2. Place the right wing up side down in the centre of the paper.
1.3. With a pencil outline the wing (incl. fittings) all around the outside edge. Please leave no or a maximum
       of 1 cm margin, as we will calculate the necessary extra space on the basis of your data.
1.4. Mark the front edge/flight direction of the wing.
1.5. Indicate the position of the handles as desired (hold the wing at the rear edge and find the point
       where it remains in a stable horizontal position).
1.6. Use the enclosed measurements form to record the required data of the wing.
1.7. Please do not use the front and the back side of the paper!!!

2. elevator
2.1. Place the assembled elevator up side down in the centre of a new section of paper roll.
       Please leave at least 30 cm space between the outlines.
2.2. With a pencil draw the outline all around the outside edge of the elevator.
2.3. Mark the front edge/flight direction.
2.4. Indicate the position of the servo arms.
2.5. Use the enclosed measurements form to record the required data of the elevator.

3. rudder
3.1. Place the rudder (incl. fuselage) on a new piece of paper. Please leave a minimum of 30 cm space
       between the outlines.
3.2. With a pencil draw the outline of the rudder plus about 10 cm of the fuselage.
3.3. Mark the position of the rear wheel.
3.4. Use the enclosed measurements form  to record the required data of the elevator.

4. Send the outlines and the completed measurements form to us.

postal address: pull-over,  Lindenstr. 37,  D-73230 Kirchheim/Teck